## Cable management tip: make them coiled [![coiled cable diy](pic/coiled-300x.png)](pic/coiled.jpg) Every wired device comes with a 1-2m cable. Like why do I need a 2m cable for the mouse? It is not like pc located on a different floor. Laptop's USB port is 10cm from the mouse, and all modern displays have USB hubs[^kbhub]. And cable hanks are ugly. Usually, people address ugliness by replacing cables with Bluetooth/RF/Wi-Fi, but meh. Coil whine, interference with other devices, random disconnects, dead battery in the moment you need it the most... So much unnecessary problems. I'm old, and I like my computer peripherals to have wires[^lan] of reasonable length. Previously I've even resoldered some USB cables to make them shorter. Recently I found an ultimate solution from The Mechanical Keyboards community - DIY coiling cables. It is not necessary for detachable cable aesthetics, the method works on all peripherals, even with a cable attached. Each coil shortens the wire section π times! And by leaving part of the cable uncoiled you can get the exact length you need. And it looks neat. Requirements: a hairdryer, stick, and 10 minutes. Genius! [Check the tutorial on YouTube](https://www.youtube.com/watch?v=_51q2zR35TE). ![](pic/comment.png) *Comments are on [HACKADAY](https://hackaday.com/2022/01/23/cables-too-long-try-cable-management-via-diy-coiling/#comments)* [^kbhub]: Btw, where all keyboards with USB hubs suddenly disappeared? [^lan]: And network over RJ45! 🏷️DIY 🏷️Tip ---